For Hella actuators TURBO-PROG allows the user to :
read actuator parameters,
store actuator parameters in
the device internal memory,
program actuator parameters,
copy actuator parameters.
The term
'actuator parameters' means the following information:
actuator type,
gearbox number of compatible
gearbox,
version of actuator firmware,
range of operation of geometry
lever.
For Siemens
actuators TURBO-PROG allows the user to :
program range of operation of
geometry lever,
check range of movement of an
actuator.
When replacing Siemens actuator (both new and used), there is a need to program
the correct range of operation. TurboProg device enables to perform this procedure
by replacing service tool VAS-6395.
Actuators supported
The programmer supports the following units:
- Hella
actuators with the following markings:
·
712120
·
730314
·
781751
·
763797
-
Siemens actuators used in turbochargers made for VW/Audi.
Kit content
TurboProg device,
DC power supply,
User Manual,
Hella connection cable,
Siemens connection cable,
USB cable and Updater Tool
Current version of update program can be found here: SOFTWARE-UPDATER