програматор

Programmer

TURBO-PROG supports two types of turbo actuators:

• Hella
• Siemens

For Hella actuators TURBO-PROG allows the user to :

1. read actuator parameters,
2. store actuator parameters in the device internal memory,
3. program actuator parameters,
4. copy actuator parameters.

The term 'actuator parameters' means the following information:

• actuator type,
• gearbox number of compatible gearbox,
• version of actuator firmware,
• range of operation of geometry lever.

For Siemens actuators TURBO-PROG allows the user to :

1. program range of operation of geometry lever,
2. check range of movement of an actuator.

When replacing Siemens actuator (both new and used), there is a need to program the correct range of operation. TurboProg device enables to perform this procedure by replacing service tool VAS-6395.


Actuators supported

The programmer supports the following units:

- Hella actuators with the following markings:

·         712120

·         730314

·         781751

·         763797

 - Siemens actuators used in turbochargers made for VW/Audi.

Kit content
 

• TurboProg device,
• DC power supply,
• User Manual,
• Hella connection cable,
• Siemens connection cable,
• USB cable and Updater Tool

Current version of update program can be found here: SOFTWARE-UPDATER

Tags:

turbo, HELLA, SIEMENS, programmer, VNT